924Board.org

WhoDak · Joined: 22 Mar 2005 Posts: 492 Location: Akron, OH

I'm going to adjust my lifters this weekend if I can get a hold of the oiler elbow and new cam seals. What part number is the oiler elbow, is it that little small piece called an adapter on the cam pulley end of the oiler tube? And is it nessicary to install new gaskets when pulling the cam cover, my engine was rebuilt about 10,000 ago. Thanks.

And if I've got another person handy to take pictures I'll try to put a step by step with pictures up for the new site too.
_________________
Mike
'82 924 N/A
'91 Toyota Pickup SR5 4x4 Xtra cab

Chrenan · Joined: 15 Jan 2003 Posts: 3903 Location: Canada

It is actually called an "Oil Tube Connector". It should be a couple of dollars at the dealership. The part number is:

052 115 707

I would definitely replace the cam cover gasket while you are in there, it can't hurt. Part number (I think):

060 198 025 1
_________________
1987 951 - M193 Version for Japan

Gram · Posted: Fri Oct 07, 2005 8:51 am Post subject:

Yep..part numbers confirmed, altho the timing cover gasket was 060-198-025 (no -1).
_________________
'82 924 NA Euro (hers)
'98 Audi A4 TDI (ours)

Gram · Posted: Fri Oct 07, 2005 8:52 am Post subject:

BTW..they called the plastic elbow a 'cam oil line adaptor'.
_________________
'82 924 NA Euro (hers)
'98 Audi A4 TDI (ours)

WhoDak · Joined: 22 Mar 2005 Posts: 492 Location: Akron, OH

Ah ok, I stopped at the Porsche shop in my town and we looked it up in the book, I went ahead and ordered the "adapter" and the gasket. Thanks guys.
_________________
Mike
'82 924 N/A
'91 Toyota Pickup SR5 4x4 Xtra cab