Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Help, intalling a turbo gauge

 
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    924Board.org Forum Index -> Posts Rescued From the Old Board
View previous topic :: View next topic  
Author Message
Guest  
PostPosted: Sat Jun 16, 2001 12:12 pm    Post subject: Reply with quote
From: Manuel
Email: manol@dccnet.com
Date: 16 Jun 2001
Time: 12:12:16

I want to install a turbo gauge, want to know if it is ok to tap into the Vac/Boost line between the intake manifold and the DIC unit under the heater box, behind the console. Is this a good place to get readings for the gauge?

Back to top
Guest  
PostPosted: Mon Jun 18, 2001 2:50 pm    Post subject: Reply with quote
From: dave2
Email: david.c.russell@lmco.com
Date: 18 Jun 2001
Time: 14:50:25

You need to take your boost reading between the turbo and the throttle plates. The easiest way to do this is to put a 1/4 npt brass tee connector at the point where the over-boost pressure switch resides.

Back to top
Display posts from previous:   
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    924Board.org Forum Index -> Posts Rescued From the Old Board All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group