924Board.org

Guest · Posted: Wed May 30, 2001 6:33 am Post subject:

From: Greg
Email: gregkilner@hotmail.com
Date: 30 May 2001
Time: 06:33:42

I am looking to change my 931 series 1 throttle body to the series 2 throttle body. Is this a simple bolt on to the manifold swap. I need to attach the s2 throttle body to turbo, pipe, that runs across the rocker because of the difference in shape at the throttle body connection. Has any one done this already will the s2 throttle body to turbo, pipe, fit at the turbo end ok?

Thanks in advance for help

Greg

Guest · Posted: Wed May 30, 2001 11:43 am Post subject:

From: larso
Email: l_porsche@hotmail.com
Date: 30 May 2001
Time: 11:43:55

if u are changing to teh single style throttle body, the bolt spacing is completely different, you woudl have to get an 81-82 manifold for it to fit.

Guest · Posted: Wed May 30, 2001 12:21 pm Post subject:

From: Greg
Email: gregkilner@hotmail.com
Date: 30 May 2001
Time: 12:21:05

so i need a complete manifold, thanks larso. But will the s2 throttle to turbo pipe bolt straight on. If it does i'm happy.

Regards

Greg

Guest · Posted: Thu May 31, 2001 2:09 am Post subject:

From: larso
Email: l_porsche@hotmail.com
Date: 31 May 2001
Time: 02:09:14

which one, the one from the throttle body to the lower duct pipe? the longest one with "924 turbo" written in red on it?
That one won't bolt on to an 80 throttle body.

The lower one that goes to the turbo fits along with teh different seals it uses, on either turbo i have found out from Bobb D.

Guest · Posted: Mon Jun 11, 2001 6:41 am Post subject:

From: Greg
Email: gregkilner@hotmail.com
Date: 11 Jun 2001
Time: 06:41:35

Sounds good,

Thanks.