924Board.org

[Project-924-1979]

Hello everyone,

A while back I made a post about stainless steel rear suspensionmounts which I was making because I did not want to pay 300+ euro's for a set of quite simple mounts.

They are now done! I sold 3 sets of mounts already and only have 2 sets left. I might make another batch of mounts if I can get these last 2 sold aswell.

They should fit 924, 944 and 968. And were developed on a 924 from '80.
I should get a fitment conformation in a week or two when the first sets are mounted to a car. Ofcourse I have carefully measured the old mounts so they should fit. The set of mount includes 4 mounts and new hardware. They have been painted to protect against seem corrosion between the steel body and the stainless mounts. The mounts are made from 316 stainless not the usual 304 so they should hold up even better to roadsalt.

I was aiming for a price of 150 but it ended up being 200 euro's for a set of mounts, which is still a considerable saving to the ones that are already out there.

Here are some pictures!








_________________
Restoring a late 1979 Porsche 924. This is my first car and my first attempt at restoring a car.
Learning a lot along the way and doing as much as I can myself.