View previous topic :: View next topic |
Author |
Message |
jimhuiz
Joined: 16 Dec 2013 Posts: 15 Location: Grand Rapids, MI
|
Posted: Tue Dec 19, 2023 2:01 am Post subject: Injector plug size? turbo head w/ carbs |
|
|
I'm refreshing a 924 Michael Mount race engine and want to replace the injector plugs which are large Allen head bolts/plugs as they're quite corroded/ugly. (it runs 50 DCO carbs)
Can anyone point me to the proper size/thread/length?
TIA!
Jim H. |
|
Back to top |
|
|
MikeJinCO
Joined: 08 Jun 2010 Posts: 1228 Location: Maysville, Colorado
|
Posted: Tue Dec 19, 2023 10:29 pm Post subject: |
|
|
When I was modifying heads I fund some I think from Belmetric Bolt. As I recall either 21 or 22mm. Measure with calipers, It is a metric pipe plug. PM sent _________________ Mike
'67 MG Midget Dp
'71 Ocelot Dsr Kawasaki 1000(under rebuild) |
|
Back to top |
|
|
MikeJinCO
Joined: 08 Jun 2010 Posts: 1228 Location: Maysville, Colorado
|
Posted: Thu Dec 21, 2023 11:54 pm Post subject: |
|
|
Update, 22mm from McMaster Carr get the ones with a sunken hex heads as the flanged one won't seal. _________________ Mike
'67 MG Midget Dp
'71 Ocelot Dsr Kawasaki 1000(under rebuild) |
|
Back to top |
|
|
jimhuiz
Joined: 16 Dec 2013 Posts: 15 Location: Grand Rapids, MI
|
Posted: Fri Dec 22, 2023 6:34 am Post subject: |
|
|
Thanks! |
|
Back to top |
|
|
924RACR
Joined: 29 Jul 2001 Posts: 8815 Location: Royal Oak, MI, USA
|
Posted: Fri Dec 29, 2023 10:10 pm Post subject: |
|
|
Hmmm, so not too sure about this. I just chased the threads in one of my heads with an M24 x 1.5 tap.
Unless the 22mm pipe thread matches up with that? _________________ Vaughan Scott
Webmeister
'79 924 #77 SCCA H Prod racecar
'82 931 Plat. Silver
#25 Hidari Firefly P2 sports prototype |
|
Back to top |
|
|
|