924Board.org

[MuteM]

Hi guys,
Question about rear spring plate.
On my 924 1979, I have two different spring plates.
So it should be?


_________________
924 1979

[Fifty50Plus]

Both sides should look like the two on the left.
_________________
1979 924 NA race car H-Prod SCCA
1982 924 NA race car - Sold
1981 924 Turbo sold
1982 924 Turbo sold
1972 911 E race car - traded for Cayenne Diesel
1975 914 1.8 Building for H-Prod SCCA

[KDJones2000]

The '76 cars had a rear suspension setup that didn't allow for ride height adjustment without reindexing the torsion bars.

Cars built after that had spring plates such that you could do some height adjustment with an eccentric bolt attached between the pivot point and the full spring plate.

It looks like you have one plate from a '76, and another plate from a later car.

Since yours is a '79, both should be 2-piece, like the one on the left as mentioned above.
_________________
1987 924S SPEC car
Team Toofah Racing
1988 944 Turbo S

[MuteM]