Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Ignition Retard Connector

 
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech.
View previous topic :: View next topic  
Author Message
kris  
Guest
PostPosted: Thu Oct 17, 2002 2:37 pm    Post subject: Reply with quote
81-931

If the Retard Connector on the drivers side fender well is disconnected, then a 7 degree difference should be seen on timing if I understand correctly.

If the 7 degree difference is NOT present, then does this mean that the Timing Control Unit is bad?
Back to top
gohim  
Guest
PostPosted: Thu Oct 17, 2002 7:28 pm    Post subject: Reply with quote
Not necessarily.

The ignition will only be retarded under specific conditions (primarily temperature, and engine speed).

If the ignition is not retard by about 7 degrees when the wire is disconnected, you could have a defective temperature sensor or other component.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech. All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group