Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Turbo Vent Measurements

 
Post new topic   Reply to topic    924Board.org Forum Index -> Body and Interior
View previous topic :: View next topic  
Author Message
924-UK  



Joined: 14 Nov 2023
Posts: 17
Location: UK
PostPosted: Wed Nov 15, 2023 10:03 pm    Post subject: Turbo Vent Measurements Reply with quote
Has anyone got a template or measurements for a DIY vent install on a 924NA front badge panel? Did a search and nothing jumps out.

Swapping the panel out is a) pretty complex as it's welded in, and b) pricey now that turbo panels have shot up in price. So I'm going to have a go at cutting / forming DIY inserts now that you can get some fairly decent 3D printed vents.

Looking for the gaps between each vent and then top or bottom gap so I can get it looking as close as possible to factory.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> Body and Interior All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group