924Board.org

Yes i have drums at the rear, but they have been adjusted for minimum play.
So the only thing that remains is the length of the push rod ( which is adjustable) to be checked for correctness.

After installing a new master brake cylinder i'm having a long brake pedal travel.
I'f noticed an adjustment of the push rod length behind the brake pedal.

How do you adjust the brake pedal push r ...

I'am about to replace the vibratic ones by the originals from Porsche and looking for a "how to" tor replace them without removing the complete engine.
Is there a little procedure to replac ...

If you have a stroboscoop to check the exact timing of your engine, that would be a prerequisite.
After that i would focus on the fuel injection.

If you give your VIN to Porsche Germany, they are able to get you all the details of your car when it left the factory, including all the ordered accesoiries.

My 924 NA has that too

Thanks Magnus for your swift response.

Do you have sparke plug cables with or without resistance?

Busy with renewal of the spark plugs, cabels and distributor and found the following on the existing items;

Spark plugs with built-in resistor (Bosch WR6)
Cables (Bremi) with 1Kohm and metal plug ...

Same issue with mine, went to a dieselpump specialist/repair center with the idle screw and they provided me with a new o-ring.
Idle rpm is stable now.

I've installed the longer one you showed in your photo and it's working fine, not touching anything (plenty room around it) and fonctioning properly.
The original shorter version is NLA, so this is t ...

I am glad it helped you out.
Found this write-up on the internet some time ago and saved it for the restauration project of my Porsche 924
Enjoy driving the Porsche...

Pierro

Could this be helpfull.......

Basic idle speed and mixture setting

Throttle stop screw setting; take a thin paper between screw and butterfly lever and position stop screw against the paper. Now ...

Thanks Ideola, This core (PET 171819031D) is readily avalable here in Europe for very low prices, see these websites......

https://www.piecesauto24.lu/oenumber/171819031d.html
http://www.vagdisc ...

Thanks Shurick, saves me a lot of headache

From my 924na/83 the heater core is dripping cooling liquid when hot (higher pression) at the in/output where the hoses are connected.
When cold there is no liquid visable.

The car is just coming ...