924Board.org

If the rebuild proves unsuccessful, I have a complete working distributor for sale from a '79.

Hi Jerry,

Welcome to the board!

I would love to provide any information about the build to support your efforts on your writing project. I particularly love the fact that there is an acronym gl ...

Thanks for the kind words guys!

Here is a very short (and not very exciting) video of my testing the serpentine belt issue fix:

https://youtu.be/EHFiANvuXNM

Lots of tuning to do this weekend ...

Vaughan linked the exact product I used. Heat Screen self-adhesive and get a roll of the matching tape to finish the edges. I bought it from Summit Racing. Running this material and the OE rubber seal ...

Hi all,

Just quick update on the project. Lots of small tidy-up items to complete before sending it off to the dyno shop. Even poorly tuned, the throttle response and pull is awesome! I will post a ...

Here is a down and dirty video of the first start.

https://www.youtube.com/embed/sPtFSgHl9O0

Lots of "button-up" little projects to get done then off to the dyno shop.

SHE LIVES!!

It's been 5 years of slow steps, but she fired right up! The supercharger sucked the elbow down so I unhooked the plumbing to it for now and disengaged the clutch on it.

Idles re ...

I installed the damn flywheel 60-degrees off.

Now I have a good reason to swap the trans out with the LSD one in the corner of the garage....

Until then, I have the front marks lined u ...

Hi Everyone,

Here is a good one. I am baffled at this.

With the flywheel -----[] mark lined up with the bellhousing cast edge, and the "dot" on the BACK of the factory camshaft pulley ...

I will celebrate with a dank beer and shooting some carb cleaner in the engine to try to start it...with gloves on this time.

Blue flag is usually signalling a driver that they are about to be lapped. Dude flashing his lights in frustration.

Absolutely doing that next...

I repeated the injector test procedure and the correct injectors are "buzzing" when turned on. Tested individually, INJ1=cyl#1 & cyl#4 and INJ2=cyl#2 &am ...

Base and ECU Controlled Timing SUCCESS!

1. This EDIS does not like the slightest degradation in battery voltage. Goes from solid spark to intermittent to none in almost a linear direction with batt ...

Hi Team,

The EDIS components are pulled from a working converted 931 (Britian's 931 that now has an AAN motor in it, he is sometimes on this board) and I replaced the coil pack with a new unit:

...

My understanding is that "Trigger" is the relationship of the VR sensor reading the 9th tooth after the missing tooth, and actual engine TDC. Markings on the motor indicating TDC do not need ...