Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Help: Need a couple of measurements on 931

 
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech.
View previous topic :: View next topic  
Author Message
kghaas  



Joined: 01 May 2017
Posts: 19
Location: Oslo, Norway

PostPosted: Sun Feb 04, 2018 6:34 am    Post subject: Help: Need a couple of measurements on 931 Reply with quote

I ned two measurements:

1. The length of the exhaust tip:
How long is the exhaust tip: Measured from the end of the silencer to the tip. I have a good Box, but the tip has been cut off. I will just weld one back on.

2. The car is fitted with a 924 front lower panel without the 9 vents on each side. My plan is to just drill and cut similar pattern in the panel. It will not be Perfect, but I might weld in some reinforcements. I need to know how wide and tall are the holes.

Any tips welcome
_________________
Knut
931 RMCH
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech. All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group