Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Extreme Dimensions? Anyome? Bueller?

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
MikesCoupeGT  



Joined: 18 Oct 2006
Posts: 469
Location: Ontario Canada

PostPosted: Wed Mar 19, 2014 4:31 am    Post subject: Extreme Dimensions? Anyome? Bueller? Reply with quote

So I have been searching the inter web looking for a Euro front and rear bumper for the 924. Just wanting to see what the prices were and to possibly lower the weight by a pound or two. I found the guys Extreme Dimensions on EvilBay and wondered if any of you have had the opportunity to deal with them. It looks like they have a 944 turbo front facia that they say fits the 924 but I am not so sure.

So any feedback, good or bad, I am just wanting to know. I have added a link so you can see what I saw. Thanks again folks.

http://extremedimensions.com/search.php?mode=search&page=1
_________________
Cheers;
MikesCoupeGT
'76 924
'83 944
''19 Elantra GT N-Line
Back to top
View user's profile Send private message Yahoo Messenger MSN Messenger
ThomasJoseph315  
Guest





PostPosted: Wed Mar 19, 2014 5:38 am    Post subject: Reply with quote

Looks like most of the "parts" they sell are just skins. You might be better off just finding a stock bumper you want off a turbo and paint it. might end up being cheaper too.

I wouldn't use this stuff. To much risk of destroying the car.
Back to top
jason c  



Joined: 13 Jan 2014
Posts: 1018
Location: Nwi

PostPosted: Wed Mar 19, 2014 10:58 am    Post subject: Reply with quote

It looks like a flimsy piece. The 951 bumper has metal riveted to it to stiffen it up. Its interesting that they don't show the side of the 924 with that bumper. The 924 fenders go down to the valance, the bumper they show fits 944 style fenders. It also shows a flange where it would meet the 944 fender, this would have to be trimmed to lay flush against the 924 fender or the fender would have to be cut. This is why they show it in a photo shop pic and no side view.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group