Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

mass air flow sensor?

 
Post new topic   Reply to topic    924Board.org Forum Index -> 924S Discussions
View previous topic :: View next topic  
Author Message
Dean924s  
Guest
PostPosted: Thu Jul 04, 2002 7:27 am    Post subject: Reply with quote
Does anyone out there know how to test the mass air flow sensor or any ideas of what is wrong with my 924s. my car will die out so that it is barely running sometime. you can't get the rpm above 2000. also when drive around 3000 rpms the car does a violent jerking. does at othe rpms but the worst at 3000. if you can help please do.
Back to top
gohim  
Guest
PostPosted: Thu Jul 04, 2002 7:42 am    Post subject: Reply with quote
You could try replacing the DME Relay, but the problem is probably a defective crankshaft ignition or positioning sensor.

You should check the clearances on the sensors.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 924S Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group