Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

2.5 to 2.8

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Dave  
Guest
PostPosted: Thu Aug 09, 2001 2:51 pm    Post subject: Reply with quote
Is it possable to bore a 924S engine out to 2.8 liters???? If so would I have to get bigger pistons or just oversized rings???
Back to top
924 turbo  
Guest
PostPosted: Thu Aug 09, 2001 4:07 pm    Post subject: Reply with quote
No, it is probably not possible. That would require a pretty big bore. You'd have to bore your engine from 100mm to about 106mm. The 2.7l 944 and S2 have a 104mm bore. That is as far as I would go. The S2 has a longer stroke.

Any time you overbore an engine, you always need to replace the pistons.
Back to top
MAS  
Guest
PostPosted: Fri Aug 10, 2001 12:50 am    Post subject: Reply with quote
Dave,

Yes it is possible... but you don't have to rebore the engine. All of the 2.5 liter engines can be re-stroked to 2.8 liters. I'm sure that some people here will know the details, but 2.8 liter stroker kits are available.

-MAS
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group