Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

3 questions.

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Ants  
Guest
PostPosted: Mon Jan 21, 2002 8:41 pm    Post subject: Reply with quote
Hey Guys i have 3 questions, i would be gratefull of help on any or all.

1. The connecting bar that connects the windscreen wipers keeps popping off (linking the motor to the other wiper), i wondered which way round its meant to fit, (it is rolled so there is a groove on one side and its rounded on the other), which faces forward, and does it matter which end is which as the ends are slightly bent (not sure if there supposed to be). How far is it supposed to click on to the knob, i can do it with my fingers but it doesn't seem very tight.

2. Do the Driving/Fog lamps work from the central console independently from the main beam, i can only get them to come on with main beam.

3. Is it possible to adjust those 2 screw fasteners that lock the boot to the body. My glass hatch has a little play in it, (even with a new seal) so i wondered if those screws can be screwed in to shorten them a bit and make the hatch fit tighter.

Thanx for your time

Ants
Back to top
eturbo924  
Guest
PostPosted: Tue Jan 22, 2002 2:26 am    Post subject: Reply with quote
I can't help you on #1
But #2 there should be a relay under the dash behind the rpm guage that keeps the driving lights off when the high beams are enguaged. (unless you wired some in yourself.)

The rear hatch posts can be adjusted, but most are rusted in place and you will just break it. You need to loosen the nut that is on the post. Then you can try to screw the shaft in with a screw driver. If it does not move you need to purchase a new one.

Eric
http://www.geocities.com/eturbo924
Back to top
kevrl  
Guest
PostPosted: Tue Jan 22, 2002 6:36 pm    Post subject: Reply with quote

In my UK spec 931 the lamps in the bumper are driving lamps not fog lamps. They can be turned on and off from a switch in the centre console, but they will only work when the headlamps are on. They are supposed to be long range driving lamps to light up the road even further ahead than the normal headlights, and they do seem to do this quite well.

Hope this helps,

Kevin
Back to top
Ants  
Guest
PostPosted: Tue Jan 22, 2002 7:53 pm    Post subject: Reply with quote
Cheerz
Yeah but i can only get mine to come on with main beam, not with just the headlights, i assume that not right. I'll cover my rear hatch bolts in penetrating oil.
Has anyone found out which way round the wiper connecting rod is meant to be???

Ants
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group