Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Exhaust manifold

 
Post new topic   This topic is locked: you cannot edit posts or make replies.    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Mikael(SWE)  
Guest
PostPosted: Sat Dec 15, 2001 12:26 am    Post subject: Reply with quote
Hi, I am about to turbo convert my 924 NA and I will weld my own manifold, is there anyone who has something like a drawing or just the data on how the drilling patterns are.. I would do as much work as possible before I dissasambe the engine, and as I have done it before... I know what a hell it is to remove the exhaust manifold..

/Micke
Back to top
John H  
Guest
PostPosted: Mon Dec 17, 2001 8:45 am    Post subject: Reply with quote
See post on the 931 section
Back to top
admin  



Joined: 29 Jul 2001
Posts: 66
Location: Everywhere
PostPosted: Mon Dec 17, 2001 10:57 am    Post subject: Reply with quote
cross-posting is a total pain. Just use the Performance forum.
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   This topic is locked: you cannot edit posts or make replies.    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group