Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Need Weber dcoe help

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
After_Thought  



Joined: 08 Oct 2019
Posts: 26
Location: Hudson ohio

PostPosted: Mon Feb 03, 2020 4:51 pm    Post subject: Need Weber dcoe help Reply with quote

Made a lot of progress on my 924. New brakes. Brake booster. Radiator. Correct jetting came in for my dcoe's and I'm having issues. Can't seem to get it to idle. I've followed a lot of instructions on the internet but still nothing. The car runs but I have to keep hitting the throttle a little to keep it going. As soon as I stop the engine dies off.

Should I turn the speed screw in farther and try to idle at a high rpm? Then start dialing back from there?

Could this be because I'm running too lean? Seems to run the best at around 1.75 - 2 turns out on the mixture screws. Some pops hear and their but it sounds good.

Sorry if I didn't give enough info I'm new too all of this
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group