Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Rear caliper holder torque + Other

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
MikeJinCO  



Joined: 08 Jun 2010
Posts: 1227
Location: Maysville, Colorado

PostPosted: Fri Apr 07, 2017 10:33 am    Post subject: Rear caliper holder torque + Other Reply with quote

I'm installing the rear caliper bracket/seal cover on my 5 lug conversion. What torque should the 4 10mm bolts be? What torque should the 12mm bolt that holds the trailing arm to TB carrier be? Haynes doesn't cover it.
_________________
Mike


'67 MG Midget Dp
'71 Ocelot Dsr Kawasaki 1000(under rebuild)
Back to top
View user's profile Send private message Visit poster's website
MikeJinCO  



Joined: 08 Jun 2010
Posts: 1227
Location: Maysville, Colorado

PostPosted: Sat Apr 08, 2017 9:43 am    Post subject: Reply with quote

Found the numbers in the Tech Specs sheet.
_________________
Mike


'67 MG Midget Dp
'71 Ocelot Dsr Kawasaki 1000(under rebuild)
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group