Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Front End Update

 
Post new topic   Reply to topic    924Board.org Forum Index -> Performance Upgrades
View previous topic :: View next topic  
Author Message
Lousailor  
Guest





PostPosted: Thu Mar 14, 2002 4:51 am    Post subject: Reply with quote

Ok it's finally time to bite the bullet and pull apart the front end. I'm going to replace the front bushings, and shocks and possibly upgrade the springs. I don't really want to change the stock ride height, but I do want to tighten up the ride (daily driver, no racing). I'm going to do most of the work myself, probably followed by a professional alignment. What is my best bet if I don't want to spend an arm and a leg? I was looking at Boge/Sachs inserts/shocks with 220 lb H&R springs. Do I need to install snubbers as well? Should I think about replacing the sway bar or rear torsion bar? Thanks. It'll be a long road to make my junker a curb queen, but I'm finally getting some free time to get the work done.

Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> Performance Upgrades All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group