924Board.org

I have no practical experience but would mixing materials with different coefficients of expansion cause problems? Chromalloy, which I think is Nichrome, has thermal expansion factor of 9 Stainless st ...

My plastic bottle test was the same as a jar test. Control pressures will be checked after the broken manifold stud is replaced

Carrera RSR, thanks for the clarification. Having just acquired the engine crane. I will be lifting the engine out following Ideola's approach described in an earlier thread.
The car (my spouse's )ha ...

I had troubles with leaking injectors and a blocked WUR mesh filter. The leaking injectors filled the sump with petrol and the pressure line back to the WUR was blocked. Too much cranking and no start ...

Carrera RSR. you recommend removing front cross member, steering rack and UJ shaft. Haynes says remove UJ joint, steering stabilizer bolts, nuts from control links, pivot bolts, then press out pivot b ...

Thanks for the advice on RHD. It looks like I should pull the engine out. Engine has been running well so I am reluctant to lift the head. I really needed this feedback on the way to go. Now to clear ...

Thank you very much for your long and detailed reply. I have a copy of Haynes. You have reassured me that Haynes is not a bad guide. I was pleased to see that steering components don't all have to be ...

I have been reading your posts and it appears that you did not lift the engine or remove the head to access the manifold. I am about to address a broken manifold stud on my 1980 931 and I would like t ...

Replacing my sunroof seal around the lift out panel did not go well. The first attempt had a squishy bulge hanging out all round on the roof and the panel would not seat down. Catches broke when I tri ...

Just had the same problem. 931 unused for years. Got it running ( took months), reversed out of the garage and found the steering was locked. Shook the steering column with no effect. Doused the area ...

Thanks for the writeup. It helped me a lot. I have just replaced these connectors with silicone, having done the timing belt so access was not too bad. I also disconnected the lower radiator hose and ...

Just what I needed to know. Thank you very much. Andrew

Trie Rennlist and got little info. Can anyone advise? I think have a fuel blockage in one of the car's injectors. I am about to remove them. They are screw in, unlike the NA 924. . Are there any speci ...