 |
924Board.org Discussion Forum of 924.org
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
924 FAQ (Technical)| Search found 123 matches |
| Author | Message |
|---|---|
 Topic: Circuit board |
|
| BillA Replies: 2 Views: 2909 |
 Forum: 931 Tech. Posted: Mon Aug 03, 2020 5:03 am Subject: Circuit board |
| Looking a little help, can anyone have a layout of this portion of the circuit
board (backside circled) as to what each wire goes, the schematics I have only have about half mentioned. If anyone is ... |
|
| Topic: Got Fuel, no crank, absolutely nothing! |
|
| BillA Replies: 1 Views: 1754 |
Forum: 931 Discussion Posted: Sat May 30, 2020 11:38 pm Subject: Got Fuel, no crank, absolutely nothing! |
| Need some help! Did some major work on the interior over the past winter/year. Repaired the dash, seats reupholstered, new shift boot, new turn signal switch and ignition starter switch (key would tur ... | |
| Topic: Cooked wiring |
|
| BillA Replies: 0 Views: 3956 |
Forum: General Discussions Posted: Sun Jun 09, 2019 12:57 pm Subject: Cooked wiring |
| Replaced the turn signal (smart switch) today, after I started it, I had smoke coming from the steering column. I shut it off immediately, pulled the steering wheel off and turn signal/wiper assmebly. ... | |
| Topic: RPM Gauges |
|
| BillA Replies: 2 Views: 4668 |
Forum: General Discussions Posted: Mon Aug 20, 2018 9:24 am Subject: RPM Gauges |
| Is it possible to run an 1983 944 RPM gauge (yellow) on an 81? Connectors are different, however can it be wired to run? Also, where can I find the black body trim or would it be better to just remove ... | |
| Topic: RPM Gauges |
|
| BillA Replies: 0 Views: 11597 |
Forum: 931 Tech. Posted: Mon Aug 20, 2018 8:40 am Subject: RPM Gauges |
| Is it possible to run an 1983 944 RPM gauge (yellow) on an 81? Connectors are different, however can it be wired to run? Also, where can I find the black body trim or would it be better to just remov ... | |
| Topic: What's the secret |
|
| BillA Replies: 1 Views: 3570 |
Forum: General Discussions Posted: Mon Feb 12, 2018 6:21 am Subject: What's the secret |
| Pull the gear shifter with the intent of putting new leather on it. Got everything out, whats the secret to pulling the new leather over the knob. I don't want to pull it to hard for fear of tearing i ... | |
| Topic: Car is now "bucking" on boost |
|
| BillA Replies: 14 Views: 16708 |
Forum: 931 Tech. Posted: Sun Jun 18, 2017 9:59 pm Subject: Finally |
| Ideola,
I think my over boost bucking issue is the result of not having installed lower charge tube bracket. I've gone through the entire twice and couldn't find anything wrong. Racking my brains ov ... |
|
| Topic: Expansion Tank |
|
| BillA Replies: 4 Views: 8846 |
Forum: 931 Tech. Posted: Mon Mar 21, 2016 12:59 am Subject: Expansion Tank |
| Does anyone know if a 944 coolant expansion tank will fit in the 931. I have one on hand and doesn't appear that it will fit due to the headlight motor.
Thanks. Bill |
|
| Topic: Gears engaged but nothing |
|
| BillA Replies: 3 Views: 1950 |
Forum: General Discussions Posted: Mon Feb 15, 2016 4:53 am Subject: Gears engaged but nothing |
| Rasta,
Finally got around to checking the CV's and you were right, failed right rear CV!!!! Thanks again Bill |
|
| Topic: Gears engaged but nothing |
|
| BillA Replies: 3 Views: 1950 |
Forum: General Discussions Posted: Fri Feb 05, 2016 1:09 pm Subject: Gears engaged but nothing |
| Rasta,
Thanks I'll check it out. |
|
| Topic: Gears engaged but nothing |
|
| BillA Replies: 3 Views: 1950 |
Forum: General Discussions Posted: Fri Feb 05, 2016 1:01 pm Subject: Gears engaged but nothing |
| So, I was driving about 15-20 mph went to shift and felt like something let loose, the vehicle stopped accelerating. I came to a complete stop on the off ramp and I tried all of the gears, but no use. ... | |
| Topic: Blew it's cookies |
|
| BillA Replies: 4 Views: 6753 |
Forum: 931 Tech. Posted: Sun Dec 13, 2015 12:20 am Subject: Blew it's cookies |
| Dan, I installed a copper head gasket and there isn't any signs of water in the oil? | |
| Topic: Blew it's cookies |
|
| BillA Replies: 4 Views: 6753 |
Forum: 931 Tech. Posted: Sat Dec 12, 2015 9:13 pm Subject: Blew it's cookies |
| One my way to work yesterday, I happen to look out the rear view mirror and saw what looked like heavy fog rolling in? However I realized very quickly it was the car! Luckily I was just pulling in t ... | |
| Topic: Tranny Swap |
|
| BillA Replies: 1 Views: 1128 |
Forum: General Discussions Posted: Fri Oct 09, 2015 9:13 am Subject: Tranny Swap |
| Did a quick search but could not find anything, can I swap out my 81 931 transmission with an 87 944 NA tranny?
Bill |
|
| Topic: 931 Aftermarket Wheels |
|
| BillA Replies: 2 Views: 1497 |
Forum: General Discussions Posted: Sun Feb 01, 2015 11:11 pm Subject: 931 Aftermarket Wheels |
| I am looking for a set of aftermarket wheels for my 931 (5 lug), Anyone have any info or a link to a site? Anyone have a set they would like to to unload?
Thanks. Bill |
|
All times are GMT + 11 Hours |
Powered by phpBB © 2001, 2005 phpBB Group