924Board.org

I've actually always had too much rear bias on my car. Over the years I've replaced the wheel cylinders, the master cylinder and rebuild the calipers. No change. The rears always want to lock up fi ...

I was wondering about that too. I saw the Passat used vented rotors

I'm late to the party but 91 Passat Calipers work.

I ordered Centric brand(PN# 14133030) 1991 Passat calipers for $36 each from rockauto.

I have failed to upload pics of them on the car, but the ...

Do they hold the door open? How do they feel. How long do they last?

https://i.imgur.com/ncC56Do.png

Haha. Omg. Thanks for sharing that and the thread link. I missed out on that. Awesome

This is hilarious

https://youtu.be/FhzyDfDetIg

When is one of you going to write a 924 song???

I made a time-laps video of installing the new spacers and wheel bearings. Thought I'd share it.

https://youtu.be/n7dSzYJmGCI

Thanks! I appreciate the info. I thought that might be wear but it was so uniform, it was hard to tell. I ordered the dune buggy parts. I'll be off-roading in no time!

Here's the stub axle with all three spacers on it.

https://i.imgur.com/sImFJMP.png

the inner race on my outer rear wheel bearing cracked. It's been a long time since I did wheel bearings and I don't remember exactly how the outer spacer that gets torqued against the wheel bearing i ...

The last time I replaced mine I did it without removing the thermostat housing. Sprayed he inside with armorall and slid it down onto the water pump and then back up onto the thermostat housing. I r ...

Hmmm. I just had a vague recollection of seeing a metal one of those. I could be wrong. If someone has a metal one and can confirm, I'd appreciate it.

My original plastic one got brittle with ...

Were these tubes originally or at some point made of metal (intake tube between the two big rubber intake boots)? I'm hoping to get a metal one if they exist. I have a vague recollection of seeing a ...

I believe by 1980 they had side impact bracing of some kind, which would get in the way of a press, and make it more difficult to straighten out the dent by hand. Also, I don't see all that much sp ...

haha

I would rather not have a speaker grill on just one door. Would my door panel attach to a 944 door?

I'm figuring I'll probably get a gutted door with no parts, and I'll have to swa ...